EasyScriber for PrimeWeld Cut60 with UPM105 machine torch

EasyScriber® for PrimeWeld Cut60 with UPM105 machine torch

$89.00USD

Compatible with the PrimeWeld Cut60 with the UPM105 machine torch. This EasyScriber installs into the UPM105 torch in seconds and requires no additional hardware or software to turn your CNC plasma table into a CNC scribing machine. If you own a PrimeWeld Cut60 with a PTM60 machine torch, or IPT60 hand torch the correct scribe can be found here PTM60/IPT60 Scribe.

Compatible Torches

Confirm your torch matches one of these models:

PrimeWeld UPM105 machine torch

UPM105 Machine Torch

Fits PrimeWeld Cut60

What You Can Scribe

Mark logos, artistic designs, precise bend lines, part numbers, hole centers, alignment marks, and other layout information on steel, aluminum, stainless, and other metals, as well as glass and mirrors. The diamond tip produces clean, permanent marks without deforming the material.

Installation & Tips

Installation is the same as changing plasma consumables and takes only seconds. Full step-by-step instructions, scribing tips, and software setup are in the User Guide.

Replacement Tips

Diamond tips last a long time under normal use. Replacement tips are available when needed.